Use beam clamps which are unidentified or uncertified for lifting applications.Never replace bolts, shackles etc without consulting the supplier.Use beam clamps on damaged or distorted beams.Force or wedge hooks of lifting appliances into the attachment eye or fitting (eg shackle).Obliquely load beam clamps without the authority of the supplier.īeam clamps are available in a range of capacities and designs.Select the beam clamp to be used and plan the lift taking the following into account: They may be adjustable or of fixed size, have scissor action, screw locking or bolt clamp fixing and be suitable for temporary or permanent applications. Type of clamp - adjustable/non-adjustable - scissor, screw or bolt action.Ĭapacity and beam size or range of beam sizes. If application is temporary or permanent. NOTE: Beam clamps are generally intended for attachment to overhead beams to act as suspension points for liftingĪppliances. Some designs are suitable for attachment to the load to provide a lifting point. The supplier should be consulted for such applications which are excluded from these instructions. Never return damaged beam clamps to storage. They should be dry, clean and protected from corrosion. Where necessary fasteners should be reassembled immediately after removal from the beam.īeam clamps should not be dropped or thrown down. The safe use of beam clamps will largely be governed by the requirements for the lifting appliance with which it is to be used but should take the following matters into account:ĭo not use defective beam clamps, lifting appliances or accessories.Įnsure the structure from which the clamp is to be suspended is undamaged and is adequate for the full load that will be imposed. If any doubt exists consult a Competent Person to confirm suitability.Įnsure the clamp is suitable for the application, correct size and profile for the beam and seats correctly. It must not cause localised overloading.Įnsure the lifting appliance is compatible with the clamp and that hooks or other attachments fit freely into the eye, shackle etc of the clamp. The clamp must be positioned directly over the centre of gravity of the load and the load must not be allowed to swing or impose an oblique loading. If two clamps are to be used in tandem the use of ancillary equipment may also be necessary, eg spreader beam.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |